HFJT1-1G01RL Without LED 1000M Ethernet RJ45 Connector With Magnetic
HFJT1-1G01RL Without LED 1000M Ethernet RJ45 Connector With Magnetic
| Categories | Connectors, Interconnects |
| Modular Connectors - Jacks With Magnetics | |
| Application-LAN | ETHERNET(NoN POE) |
| Connector Type | RJ45 |
| Number of Positions/Contacts | 8p10c |
| Number of Ports | 1×1 |
| Applications Speed | 100/1000 Base-T, AutoMDIX |
| Mounting Type | Through Hole |
| Orientation | 90° Angle (Right) |
| Termination | Solder |
| Height Above Board | 0.537″ (13.65mm) |
| LED Color | Without LED |
| Shielding | Shielded, EMI Finger |
| Features | Board Guide |
| Tab Direction | UP |
| Contact Material | Phosphor Bronze |
| Packaging | Tray |
| Operating Temperature | -40°C ~ 85°C |
| Contact Material Plating Thickness | Gold 6.00µin/15.00µin/30.00µin/50.00µin |
| Shield Material | Brass |
| Housing Material | Thermoplastic |
| RoHS Compliant | YES-RoHS-5 WIth Lead in Solder Exemption |
7 problems that need to be paid attention to when using RJ connector
1. Use successive power and ground plane layers;
2. Try to prevent right angles from being used in wiring;
3. Impedance control, reflection and signal terminal matching;
4. Physically block the active components against noise devices;
5. The length of the differential pair wiring should be equal to ensure a good compression ratio at the receiving end;
6. Crosstalk questions should be considered in high-speed circuit design, including near-end crosstalk and far-end crosstalk;
7. Power supply decoupling question, that is to say, the power supply added to the circuit must be decoupled by inductance and capacitance.
